Requirements check
Lighting
EU/UK energy labelling and ecodesign rules for light sources (e.g. Regulations (EU) 2019/2015 and 2019/2020) apply to most lamps and are beyond this dataset — additional sector rules apply. Photobiological safety (blue-light hazard) is assessed via EN 62471 under LVD harmonised standards — verify for high-intensity LEDs. Novelty lights designed to appeal to children for play can qualify as toys — verify. Smart bulbs are radio equipment: RED / UK Radio Equipment Regulations replace the separate LVD and EMC listings. Sealed-battery emergency or portable lights face the EU Battery Regulation removability rule from February 2027.
European Union7 instruments
Requires electrical and electronic equipment not to generate excessive electromagnetic disturbance and to be adequately immune to it. Compliance is normally self-assessed and leads to CE marking.
Key obligations
- 01Ensure apparatus is designed and manufactured in accordance with the essential requirements of Annex I (limited electromagnetic emissions; adequate immunity for intended use) — Article 7.source
- 02Draw up the technical documentation and carry out the relevant conformity assessment procedure (Article 7(2)).source
- 03Draw up an EU Declaration of Conformity and affix the CE marking; keep the technical documentation and DoC for 10 years (Article 7(2)-(3)).source
- 04Provide information on any specific precautions needed when the apparatus is assembled, installed, maintained or used, so that it preserves EMC conformity.sourceUnverified — check source
The EU's baseline safety law for consumer products, applicable since 13 December 2024. It replaces the General Product Safety Directive and adds duties around traceability, online selling, recalls and having a responsible economic operator in the EU.
Key obligations
- 01Only place safe products on the market. Safety is assessed against the product's characteristics, packaging, instructions, the consumers who will use it, its appearance (food-imitating products) and, where relevant, cybersecurity features.source
- 02A product may only be placed on the EU market if there is a responsible economic operator established in the EU — an EU manufacturer, importer, authorised representative or fulfilment service provider (Article 16).source
- 03Carry out an internal risk analysis and draw up technical documentation; keep product identification and traceability information available (manufacturers, importers and distributors each have tiered duties).source
- 04Report accidents caused by your products and notify dangerous products to the authorities through the Safety Business Gateway.source
Sets the electrical safety requirements for equipment operating between 50–1000 V AC or 75–1500 V DC. Compliance is entirely self-assessed — no notified body is involved — and leads to CE marking.
Key obligations
- 01Design and manufacture equipment in accordance with the safety objectives, and carry out the internal production control conformity assessment (Article 6).source
- 02Draw up technical documentation (Annex III): general description, design and manufacturing drawings, list of harmonised standards applied, design calculations, test reports and a risk analysis/assessment.source
- 03Draw up an EU Declaration of Conformity, affix the CE marking, and keep both the technical documentation and the DoC for 10 years after the equipment is placed on the market.source
- 04Mark the equipment with a type/batch/serial number and your name, registered trade name and postal address, and provide instructions and safety information in a language easily understood by consumers.source
The EU's enforcement framework for product rules. Its Article 4 is the practical blocker for online sellers: since 16 July 2021, most CE-marked goods can only be placed on the EU market if an economic operator established in the EU is responsible for compliance tasks — and that operator's contact details must accompany the product.
Key obligations
- 01A product covered by the Article 4 list may only be placed on the EU market if there is an economic operator established in the Union responsible for the Article 4 tasks (applies since 16 July 2021).source
- 02That operator can be: the manufacturer established in the EU; an importer (where the manufacturer is not established in the EU); an authorised representative with a written mandate; or an EU-established fulfilment service provider handling the products (Article 4(2)).source
- 03The operator's tasks (Article 4(3)): verify that the EU Declaration of Conformity and technical documentation exist and keep the DoC available; provide information and documentation to authorities on request; inform authorities when a product presents a risk; cooperate on corrective action.source
- 04The name, registered trade name or trade mark and contact details (including postal address) of the Article 4 operator must be indicated on the product or on its packaging, the parcel or an accompanying document (Article 4(4)).source
The EU's chemicals regulation. For physical-product (article) sellers the practical duties are: communicating Candidate List substances of very high concern (SVHCs) above 0.1% down the supply chain and to consumers, notifying ECHA in some cases, and respecting the Annex XVII restrictions. Full chemical registration applies to substance manufacturers/importers, not typical article sellers.
Key obligations
- 01Article 33(1): if an article contains a Candidate List SVHC above 0.1% weight by weight, provide recipients (businesses in the supply chain) with sufficient information for safe use — at minimum the name of that substance. This applies per article within a complex product.source
- 02Article 33(2): on request from a consumer, provide the same safe-use information (at minimum the substance name) within 45 days, free of charge.source
- 03Article 7(2): EU producers/importers of articles must notify ECHA when a Candidate List substance is present above 0.1% w/w AND its total quantity in those articles exceeds 1 tonne per producer/importer per year — no later than 6 months after the substance is added to the Candidate List. Notification is not required where exposure of humans and the environment can be excluded.source
- 04Notify articles containing Candidate List SVHCs above 0.1% w/w to ECHA's SCIP database (a duty under the Waste Framework Directive, submitted via ECHA).sourceUnverified — check source
Restricts ten hazardous substances — including lead, mercury, cadmium and four phthalates — in electrical and electronic equipment. Compliance is self-assessed, documented through material declarations, and forms part of the CE marking.
Key obligations
- 01Ensure homogeneous materials do not exceed the Annex II maximum concentrations: 0.1% by weight for lead, mercury, hexavalent chromium, PBB, PBDE, DEHP, BBP, DBP and DIBP; 0.01% for cadmium.source
- 02The four phthalates (DEHP, BBP, DBP, DIBP) were added by Delegated Directive (EU) 2015/863 and apply to most EEE from 22 July 2019 (medical devices and monitoring/control instruments from 22 July 2021).source
- 03Carry out the internal production control procedure in line with Module A of Decision 768/2008/EC, draw up technical documentation, and keep it (with the EU Declaration of Conformity) for 10 years (Article 7).source
- 04Draw up an EU Declaration of Conformity and affix the CE marking to the finished product (Article 7).source
Extended producer responsibility for electronics: producers must register in each EU country where they sell, finance the collection and recycling of e-waste, and mark products with the crossed-out wheeled bin symbol. It is a waste-law obligation, separate from CE marking.
Key obligations
- 01Register as a producer in the national WEEE register of each Member State where you place EEE on the market before selling there (Article 16).source
- 02Finance at least the collection, treatment, recovery and environmentally sound disposal of WEEE from private households (Article 12; Article 13 covers non-household WEEE) — in practice usually via a producer compliance scheme.source
- 03Distance sellers: appoint an authorised representative in each Member State where you sell but are not established, to fulfil the producer obligations there (Article 17).source
- 04Mark EEE with the crossed-out wheeled bin symbol shown in Annex IX (Article 14(4)), plus a mark identifying that it was placed on the market after 13 August 2005 (Article 15(2)).source
Documents you will need
Deduplicated across everything above
- EU Declaration of ConformityKept for 10 years after the apparatus is placed on the market.source
- Technical documentationIncludes the EMC assessment and test reports; kept for 10 years.source
- Instructions and EMC use informationInformation needed to install/use the apparatus in accordance with its intended purpose without breaching EMC requirements.source
- Traceability informationProduct identification (type/batch/serial) plus manufacturer and EU responsible operator contact details must accompany the product.source
- Technical file (Annex III)Description, drawings, standards list, design calculations, test reports, risk analysis and assessment.source
- Instructions and safety informationIn a language easily understood by consumers/end-users in the Member State concerned.source
- Written mandate (when using an authorised representative)The authorised representative must hold a written mandate covering the Article 4 tasks.source
- EU Declaration of Conformity + technical documentation availabilityThe EU operator must be able to verify these exist and produce them for authorities on request.source
- Supplier declarations / full material disclosuresEvidence that Candidate List SVHCs are below 0.1% w/w per article, or the basis of your Article 33 communications.source
- Article 33 safe-use communicationsRecords of the information passed to recipients and provided to consumers within the 45-day deadline.source
- Technical documentation per EN IEC 63000Material declarations, analytical test reports and supplier certificates organised per the harmonised documentation standard.source
- National producer register entries and registration numbersMany Member States require the WEEE registration number on invoices/webshop; requirements vary nationally.source
- User informationInstructions/packaging must inform users about separate collection and the crossed-out bin symbol.source
- Treatment information for recyclersFree of charge, identifying components, materials and the location of dangerous substances (Article 15).source
Track this product to done
Save this result as a live checklist: every requirement, document and deadline above, with status tracking and a document vault. Free for one product.